26
3.6 Drawing hot water
Two different jets are supplied with this coffee machine:
– A steam and milk foam jet (12) with a small opening.
– A hot water jet (12a) with a larger opening.
☛
The steam and milk foam jet (12) is mounted from the factory. Before drawing
hot water, change the jet first. (By screwing out the lower black plastic piece, the
steam and milk foam jet (12) can be removed and the hot water jet (12a) can be
screwed in.)
• Place your cup under the jet (12a).
• Turn the steam/hot water dial (11) to the right. The
symbol blinks while hot water
is flowing out of the jet.
• When your cup is filled with the desired amount of water turn the dial (11) back to 0.
☛
Caution: Very hot water and danger of burns!
The water from the jet can
spray around, and the hot water jet (12a) is very hot when in use. Allow the jet
to cool off for a few minutes before touching it.
3.7 Drawing steam and milk foam
Make sure that the correct steam and milk foam jet (12) is mounted. (See section 3.6
Drawing hot water.)
• Press the steam preheating button (10). The
symbol will blink.
• As soon as the system is ready, the
symbol blinks and the
symbol lights up.
• Insert the jet (12) into the cup with the liquid to be heated.
• Turn the steam/hot water dial (11) to the right.
Please note:
Water will first come out
and then steam.
• By turning back the dial (11) to 0, the process is stopped.
• Press the steam preheating button (10) and the coffee machine will be reset for
normal operation.
☛
You can make steam for up to two minutes. The machine will then turn off auto-
matically. By turning the knob (11) back and forth, you can continue the process.
☛
Caution: Very hot steam and danger of burns!
Only touch the jet on the black
plastic part!
☛
Dried residue on the jet after making milk foam is difficult to remove. You should
therefore clean it immediately after it has cooled off!
