Rotary MCH418, Установка-Безопасность-Эксплуатация-Техническое обслуживание

Страница: 10 / 16

10
Maintenance Instructions
WARNING
If you are not completely familiar with
automotive lift maintenance procedures Stop: contact
factory for instructions.
To Avoid Personal Injury: Permit only qualified personnel to
perform maintenance on this equipment.
• Never overload lift. See capacity nameplate.
• Never direct water stream at control box or cable
connections.
• Never place sharp objects on Communication Cables or
drive over cables.
• Always keep locking latch free.
• Always keep all bolts tight.
• Always keep lift and lift area clean.
• Monthly: Check Emergency Stop: Push the “Emergency
Stop” button. Columns should be inoperative with any
emergency stop button depressed.
• Monthly Lubrication
1. Lower lift, check oil level in oil tanks on each column:
Open Power Unit Cover. Remove oil cap and check
oil level. It should just be touching the dipstick. If
necessary, fill with ISOVG32 hydraulic oil.
2. Oil the bushings on the jack handle and brake
mechanism assembly.
• Monthly: Examine Cords: Check the condition of the
charging cord and the communication cords on each
column. Replace worn or broken cords as required.
• Change fluid in accordance with oil manufacturer's
recommendations:
1. Columns must be completely lowered.
2. Remove cover panel from power unit.
3. Remove oil from power unit tank.
4. Refill with approximately 11-1/2 quarts (11 liters) of
hydraulic oil meeting ISOVG32 specifications, into each
tank. Fill until fluid is just barely visible on dipstick.
5. Check oil level in oil tanks on each column, add if
necessary.
6. Dispose of waste oil according to legal regulations.