G
H
Pg. 4/14
I
Start with the
2 center clips
illustrated.
With the top surface of each clip parallel to the top
of the tower, use a marker to mark the center mark
for each bimini clip. Remove each center clip from
the rear tower tube so they are out of the way of the
center mark.
Center punch the 2 marker points on
the masking tape.
2 inch Low Tack
Masking Tape
Fabric-Clips Installation:
Step 2
Fabric-Clips Installation:
Step 3
Marker Point
Snap the 6 bimini clips around the rear tube of the tower
as illustrated. Adjust the bimini clip locations until they are
symmetrical and the fabric is tight and wrinkle free.
Rear Tower Tube
Center Bimini Clips
Fabric-Clips Installation:
Step 1
Bird’s Eye View
**IMPORTANT**
The position of the
center Clips is the
most important to
begin with. Make sure
that the clips are
positioned along the
rear tower tube so
that the fabric is
centered around the
Light Housing.
Light Housing
Center Clips
Prior to marking the center points for the 2 center clips in Step I, it is
important to pull/rotate the clips until the clip top surface is parallel to
the top of the tower. With a good grasp on each clip, rotate them until
the top is parallel then mark the center point with a black marker.
Make sure your fabric stays centered around the light housing
Side View
Top View
2 inch Low Tack
Masking Tape
