J
Pg. 5/14
K
L
Fabric-Clips Installation:
Step 4
Fabric-Clips Installation:
Step 5
Using a cordless drill and a 9/64” drill bit, drill holes
through the tower where you made the 2 center
punch marks. Using a tap and a 10-24 UNC bit,
carefully tap each of the holes you just drilled.
***When drilling the holes
for your bimini clip it is
important to drill the
holes perpendicular to
the location of the hole to
be drilled. This will allow
for an optimal fit of the
bimini clip.***
Side View
Center Punch Mark
x2
Remove the masking around the 2 newly drilled
holes only. Mount the 2 trimmed clip locators to the
newly drilled and tapped holes with 2 of the
provided bimini clip bolts from your bimini box.
Apply a small amount of red Loctite to each bolt.
Using a Phillips screwdriver, attach the bimini clip
locators to the tower.
Do not overtighten these screws.
9/64” Drill Bit
THREADLOCKER
2 inch Low Tack
Masking Tape
2:
Grab a sharp utility knife and carefully cut away the
locator posts on each bimini clip and locator. There are 6
posts on each bimini clip and locator. When trimming the
posts always cut away from yourself and the tower.
Trimming the locator
posts
Locator Posts
***Clips are attached to the bimini Canvas. Bimini
Canvas is not illustrated for image clarity***
Side View
Clip Locator
Push and Break
1:
Push and break off the clip locator from
the 2 center bimini clips.
