Check this distance to make sure the stainless arm is
bottomed out in Anchor tubes.
Equal
Equal
Equal
Equal
13.5”
Velcro Straps
Rear Tube
5
Area 53 Bimini Install
a
tion Instr
u
ctions
www.roswellmarine.com
K
L
We recommend this step be done with the Velcro
straps released. Test your quick release pins on both
sides of the bimini by removing and re-inserting each
pin a few times. If either is difficult to remove and/or
re-insert please proceed to the next page for trouble-
shooting.
J
Place the fabric over the tower and loosely secure it along the rear tower tube and bimini frame using the velcro straps.
For optimal fabric fit you should attach the velcro straps starting with the center ones and working your way to the
outer ones. After attching the velcro straps level the bimini frame and adjust the position of the mounting arms to get
the fabric tensions as close to “not-to-tight and not-to-loose” as possible. Tighten up the velcro straps and adjust until
best fit is achieved.
I
With one person on each side of the frame and canvas, slide the stainless arms into the anchor tubes on each side. This
is where you may have to adjust the angle of the anchor tubes that were left loose in the previous step. Make sure the
stainless arms are bottomed out in the Anchor tubes. Note: You can apply some silicon lubricant to the stainless arms to
make them easier to insert.
Two people are required for this step
Note: Canvas not shown for image clarity
If there are no difficulties inserting or removing the
quick release pins, you can now install the mounting
clamp set screw. Apply red thread lock to the screws
before installing. Tighten and apply red thread lock to
the clamp bolts.
Torque to 15 Ft.Lbs
THREADLOCKER
RED
3/16”
(x2)
Tighten and apply
thread lock to clamp
bolts
