TOOLS NEEDED
3/16”
Allen Key
PACKAGE CONTENTS
(x1) Port Front Bow
(x1) Starboard Front Bow
(x2) Center Tube
(x1) Starboard
Mounting Tube
(x1) Port
Mounting Tube
(x2) Stainless
Arms
(x2) Middle Bow
(x4) Plastic Clamp
Inserts
(x2) Mounting Tube
Clamp
(x1) Canvas
(x8) #8 Self Drilling and
Tapping Phillips Screws
(x2) 5/16”
Shoulder Bolt
(x4) 1/4-20 x 0.75”
(x2) 3/8-16 x 0.50”
Set Screw
(x4) 1.115”x0.541”
Nylon Washer
(x2) Pivot Washer
THREADLOCKER
RED
Threadlock
Tape Measure
Drop Cloth
Drill
5/16”
Drill Bit
Prepare your workspace:
Clear an area near the boat. Make sure there is an unobstructed path from the
boat to the setup area. We suggest assembling the bimini on a dropcloth to
prevent damaging or scratching the finish of the parts. Make sure there are no
overhead obstructions (rafters, garage door, hanging light fixtures, etc.)
Unpack the bimini:
Be careful to avoid marking or scratching when removing the bimini from its
packaging. As you unpack each part, carefully lay them out on the dropcloth.
Note:
Remove the hardware as necessary to ensure that parts are not lost.
Torque
Wrench
A
Before assembling anything measure your tower width as illustrated. This measurement
will make sure you have the correct bimini for your tower. Measure from the center of
the port foot to the center of the starboard foot. If your tower is between 76 and 88in
make sure you have a narrow bimini (C910-1740). If your tower is between 88in and
102in make sure you have a wide bimini (C910-1741).
76-88” Narrow
88-102” Wide
#2 Phillips
Screwdriver
#2 Phillips
Driver Bit
2
Area 53 Bimini Install
a
tion Instr
u
ctions
www.roswellmarine.com
