Ross YOYAGER X1, Руководство по обслуживанию, Страница: 55 / 62

Voyager Maintenance Guide (v02) Hardware Maintenance • 5–23
Replacing Power Supplies
The Voyager system has two identical hot-swappable power supply modules, located at the rear of the system on the
left-hand side. Since the system requires a minimum of one power supply module to operate, only one power supply
can be hot-swapped at a time.
Keep the following safety information in mind while removing a power supply from the Voyager system:
• Always ground yourself before touching electronic equipment.
• When removing a power supply module, always support the module with two hands to help prevent dropping
it.
Removing a Power Supply Module
To remove a power supply module from the Voyager system:
1. At the back of the Voyager system, disconnect the power cord from the power supply module to be removed.
2. Loosen the thumbscrew on the bottom right of the power supply module.
3. Push up on the silver release lever.
Protective Earth
— Static discharge can cause serious damage to sensitive devices. Touch the
chassis to dissipate static charge before removing power supplies from the system, and exercise proper
grounding precautions when working around the Voyager system.
Warning
— Hazardous voltages capable of delivering electric shock remain within the power supply
module for a period of time after removal from the system.
Ross Video power suppliy modules are intended to be factory serviced by qualified Ross Video service
personnel only. Users should only remove and replace the power supply modules.
When removing or replacing a power supply module, follow the instructions below:
• Disconnect the power cord from the power supply module or the power supply from AC mains before
removing or replacing a power supply module.
• Do not open or try to remove the casing of the power supply module.
Failure to follow these instructions can result in death or serious injury.