Ross openGear SEA-8803, Руководство пользователя

Страница: 19 / 44

SEA-8803 User Manual (Iss. 02) Installation • 2–3
Installing the SEA-8803
The SEA-8803 can be installed in the DFR-8321 series frames and the OG3-FR series frames
using one of the supported rear modules.The procedure for installing the rear module and card in
your openGear frame is the same regardless of the rear module used.
Supported Rear Modules
The Rear Module depends on the configuration you wish to use:
• 1x8 configuration — The 8320AR-300 , or 8320AR-306 Full Rear Module is required.
• 1x4 configuration — The 8320AR-301 Split Rear Module is required.
Installing a Card
You must first install the rear module in the frame and then install the card in the appropriate slot
within an openGear frame. This section outlines how to perform both tasks.
To install the rear module in the openGear frame
1. Ensure that the openGear frame is properly installed.
2. On the rear of the openGear frame, locate the card frame slot.
3. Remove the Blank Plate from the rear of the slot you have chosen for card installation.
4. As shown in Figure 2.1 , seat the bottom of the rear module in the seating slot at the base
of the frame’s back plane.
Figure 2.1 Rear Module Installation in an OG3-FR Series Frame (Cards not shown)
5.
Align the top hole of the rear module with the screw hole on the top edge of the frame
back plane.
Notice
— Ensure that you install the SEA-8803 using one of the supported rear modules
listed below. Installing the SEA-8803 with an unsupported rear module can damage the card,
the rear module, or both.
Screw Hole
Module Seating Slots