DAC-9213-PVM User Manual (Iss. 02B)
Setup and Operation
•
3-1
Setup and Operation
In This Chapter
This section provides details of all operating modes and features.
The following topics are discussed:
•
Cable Connections
•
User Controls
•
Setup and Configuration
•
Function Setup and Configuration Menu Table
•
Function Menu Notes
Note
Throughout this section, the term SDI is used universally to
indicate either SD-SDI or HD-SDI signals.
Cable Connections
Input Cabling
Connect the system signal to the SDI IN BNC.
Output Cabling
Connect the reclocked output BNCs to other devices as required. It is not
necessary to terminate unused outputs.
Using the supplied
CBL-3BNC-MM, 2M
3BNC male to 3BNC male two
meter cable or equivalent, connect the component video output from the DAC-
9213-PVM to the corresponding component analog monitor input according to
the designations indicated on the chassis faceplate and the monitor’s input
BNCs. See Figure 3.
Note
The Sony monitor’s component input must be selected, and
the monitor must be set up for the same format as the
DAC-9213-PVM’S output video format.