SLF 2250/4000
Hydromatic Stinger
Page - 73 -
© 2014
Roof Turret Operation
2
4
6
8
10
12
N2
7
9
11
1
3
5
Roof turret RM 60 C - operation with water or water/foam
Water operation:
- Operate the pump as mentioned in the
◊
"Tank Suction Operation" or
◊
"Drafting Operation from Open Water Source" or
◊
"Hydrant / Supply Operation" pump panel operation chapter.
Water/foam operation:
- Adjust the foam proportioning rate for the turret:
◊
Bring adjustment lever (J87t) to the desired position.
- Operate the pump as mentioned in the
◊
"Foam Operation" pump panel operation chapter.
- Engage the remote control (U31):
◊
Press only switch (11) for 3 seconds.
◊
The remote control is activated.
- Choose the operating device:
◊
Press shift switch (11) + (7) until the roof turret is choosen.
◊
The symbol of the "turret 1" appears on the display (N2).
Note: This is only necessary if more operating devices are
controled by one remote control (U31) (e.g. light mast, roof
turret and the bumper turret).
- Engage the roof turret:
◊
Press shift switch (11) + (9) to engage the roof turret.
- Direct the turret to the desired position by using switches (1),
(2), (3) and (4).
- Open the turret discharge valve:
◊
Press switch (9).
- Open the foam compound pressure valve for turret line:
◊
Press switch (11) + (1).
- Adjust required discharge pressure:
◊
Press switch (7) to increase the pump speed.
◊
Press switch (8) to decrease the pump speed.
- To reduce to half discharge rate press switch (11) + (5).
- To go back to full discharge rate press switch (11) + (6).
- To generate spray pattern, press switch (6) or for full jet press
switch (5). This can be done whilst discharging.
U31
J87t
