Rosen Entertainment Systems
Copyright 2007 all rights reserved
HE0780DInstallation Guide
AP1024 Rev A
Page 3
5 Mounting the HE0780D electronics into the headrest bucket
You will need to mount the HE0780D electronics unit into the headrest bucket. The following steps will guide
you through this process.
CAUTION!
Do NOT press directly on the surface of the LCD. This will cause permanent damage
to the LCD which will not be covered by warranty.
Always
REMOVE ANY SLACK
in the cables during assembly. Failure to follow this step may
cause damage to the cables.
Step 1:
Place the lower edge of the HE0780D unit into the
headrest bucket first. Be sure that the lower edge of the
HE0780D unit does NOT go below the top surface of the
headrest bucket (see figure 3). Use caution so the material
on the bucket is not damaged.
Step 2:
Pull any additional slack created in the cables
through the headrest posts.
Step 3:
Align electronics on electronics mounting bracket.
Push firmly, the side latch will “click” to lock monitor in
place. Remove excess cable slack! Use caution NOT to
press on the LCD surface as this can cause permanent
damage to the LCD. (see figure 4)
IMPORTANT!
Do not force electronics into the bracket, the components are designed to easily align
when properly installed
.
BE 100% CERTAIN TO REMOVE ALL SLACK in the cables during assembly of the
units. Failure to follow this step may damage the unit, internal cables or prevent the
unit from properly closing. If you feel resistance when closing the unit, please confirm
that all cable slack has been removed.
Fig. 3
Fig. 4
