Rosemount CT4215, Справочное руководство

Страница: 27 / 56

7. Attach the reject mechanism.
WARNING!
DRILL INJURY
Be careful to avoid injuring hands and eyes when drilling. Wear correct PPE at all times.
a. Drill two location holes into the track side face in the approximate positions
required for the reject mechanism.
Use track location T slots if available (no drilling required).
b. Attach the reject mechanism on the track in the approximate position required
using two M6 socket head cap screws, two spring washers, and two washers.
c. Leave the reject mechanism loose by hand tightening the fasteners only.
d. Secure the reject mechanism in place using previously fitted bolts.
e. Torque fasteners to 5.6 ft-lb. (7.6 Nm).
f. Adjust the angle and depth of the the reject mechanism as required. Loosen the
side bolts to adjust the angle and then tighten them when aligned.
8. Attach the sample head.
WARNING!
DRILL INJURY
Be careful to avoid injuring hands and eyes when drilling. Wear correct PPE at all times.
a. Drill four location holes into the track side face in the approximate position
required for the sample head.
Use track location T slots if available (no drilling required).
b. Place the sample head on the track in the approximate position required using
four M6 socket head cap screws, two spring washers, and two washers.
c. Leave the sample head loose by hand tightening the fasteners only.
d. Secure the sample head in place using previously fitted fixings.
e. Torque fasteners to 5.6 ft-lb. (7.6 Nm).
f. Adjust the sample head height to the track as required to suit pack thickness.
Loosen side bolts to adjust the height on the slots and then tighten them when
aligned to the required pack height.
Installation
Reference Manual 15