Rosemount 702, Справочное руководство

Страница: 15 / 68

Reference Manual
00809-0200-4702, Rev BA
June 2010
2-3
Rosemount 702
DEVICE NETWORK
CONFIGURATION
To communicate with the Gateway, and ultimately the Information System, the
transmitter must be configured to communicate with the wireless network.
Using a Field Communicator or AMS Wireless Configurator, enter the
Network ID and Join Key so they match the Network ID and Join Key of the
Gateway and the other devices in the network. If the Network ID and Join Key
are not identical, the transmitter will not communicate with the network. The
Network ID and Join Key may be obtained from the Gateway on the
Setup>Network>Settings page on the web server. Using a Field
Communicator, the Network ID can be configured by entering the Fast Key
Sequence: 2, 2, 1, 1. The Join Key can also be configured using a Field
Communicator with the Fast Key Sequence: 2, 2, 1, 2.
The final device network configuration piece is the Update Rate which, by
default, is 1 minute. It can be changed at commissioning, or at any time, by
using AMS Wireless Configurator or the Gateway’s web server. The Update
Rate should be between 8 seconds and 60 minutes. To change the Update
Rate with a Field Communicator, use the Fast Key Sequence: 2, 2, 1, 3.
If doing a bench top initial configuration, after completion remove the power
module until installation. When the device is installed, insert he power module
and close the housing cover securely. Always ensure a proper seal so that
metal touches metal, but do not over tighten.
Dry Contact Inputs,
Measurement Option
Code 22
Figure 2-1. 702 Terminal Block
Connect the HART communication leads to the COMM terminals on the
terminal block.
1
2
4
3