G A L A X Y ® A U R O U R A L S C O N F I G U R A T I O N A N D S Y S T E M I N T E G R A T I O N G U I D E
23
Section 2 Basic Setup
Section 2
Basic Setup
2.0 Basic Setup
2.1 Drive integration and Cable Connections
2.1.1 Indicators and switch descriptions Figure 2.1
The Aurora LS front panel has indictors for good and fault conditions and activity. Green LEDs
indicate good condition, red LEDs indicate a problem that will also log an error and send an email.
The alarm reset needs to be depressed to silence the alarm. The Reset PB is used to restart the
Aurora LS. The Power PB is used to power up the Aurora LS.
The power switch is used to turn the unit on. However, do not use it to turn the unit off, unless
there is no other way. To turn on the unit, press the power switch momentarily. To turn it off,
press and hold it for 8 seconds. The reset switch also should not be used unless there is no
alternative. To the right of the two switches is the Power LED.
This illuminates when
power is on. To the right of the power LED is the Aurora LS OS DOM activity LED
. This
LED will light intermittently during normal operation. Next to the power LED are two network
LEDs.
These LEDs will light when there is activity from the management
network ports they correspond to on the rear. Next to these is a temperature / fan fail warning
Figure 2.1
