Page 13
7.7 Mounting the side fascia
Warning
ALWAYS switch off mains voltage during assembly
Check national regulations to determine the correct location of the control unit.
7.6.2 By screwing the front fascia
fittings into the worktop you
pull the front fascia upward.
Finally tighten the screws on
the side of the support arm.
7.7.1 Furniture fittings are provided
with the frame to keep the
wooden side fascia up against
the worktop.
7.8
Mounting the control unit
7.8.1 The 2 special nuts on the control box plate are turned vertically,
making them fit into the long track in the alu profile. The plate is
positioned on the front of the alu profile and the 2 M6 screws are
tightened. (The special nuts are automatically turned in place,
when the screws are tightened)
