Page 10
Where you have an adjustable leg
always
position
a support arm directly over it. Do not
adjust the tilting of the arm supports that are positioned on top of the legs (see 6.5).
If the sink or hotplate is placed at the middle of the worktop, move the third leg if any, to the
right or left to ensure that the leg and support arm are fitted in the immediate vicinity of the
sink, hotplate etc.
7.2.1 Place the frame against the wall and
align it. Adjust the two threaded bolts
under the legs to ensure that the frame
is horizontal.
To obtain the correct height (65-95 cm
without worktop) adjust the threaded
bolt to each leg.
After mounting, turn the threaded
bolts up so they are hidden by the
leg.
Mark and drill the holes for fastening.
Fasten the frame to the wall by means
of screws and raw plugs suiting the
material of the wall.
7.2 Mounting the frame on the wall
7.1.11
Move the stop rings on the spindle
to both sides, so that the stop ring
always faces the leg. Secure it by
fastening the screw in the stop rings.
7.2.2
Misalignments up to 0,45 cm on the
wall may be adjusted by fitting the
provided spacers (0,15 cm)
between the legs and the wall.
Loosen the legs a bit and slide the
spacers in between the wall and the
legs, as required, at the top or
bottom depending on whether the
wall is vertical.
