ROOTS RootsScrub E4043, Руководство оператора

Страница: 24 / 40

24 RootsScrub E4043
MACHINE OPERATION
SCRUBBING PROCEDURE
Scrubbing:
Useful Tips for Scrubbing:
a
b
c
d
e
è
Ensure that fresh water tank is filled with clean water.
è
Ensure that the dirty water tank is empty.
è
Install the recommended brush.
è
Move machine to work area.
è
Plug power cord into mains with a rating of 230V/50Hz only.
è
Switch On brush motor switch (a).
è
Switch On suction turbine switch (b)
è
Set water flow using the water flow control knob (c).
è
Lower the squeegee (d).
è
Lower the brush head (e).
è
Move machine forward to start scrubbing.
è
The dirty water sucked by the squeegee will be collected in
the dirty water tank via the suction hose and flow diverter
(f).
è The suction turbine will automatically switch Off when the
dirty water tank is full as the mechanical float (g)/electrical
float (h) system is activated.
è
Stop scrubbing operations.
è
Drain dirty water tank completely and then resume
scrubbing operations.
After lowering the brush move the machine
immediately; otherwise the brush might leave
traces on the floor. Lift the squeegee during
reverse travel. When passing over dormers with a height of more
than 0.7° in =10 mm, the brush head must be turned off and the
brush must be lifted up.
Attention!
!
It is dangerous to pass over the power supply cable while
the brush is rotating.
!
Cleaning of floor areas starts from the outlet socket and is
effected stripe by stripe.
!
In case of unoccupied areas it will be useful to clean at first
the border areas, passing with the machine along those
areas in counterclockwise sense.
!
Cleaning of the remaining areas then should be effected
stripe by stripe, starting from the outlet socket.
!
Partially occupied areas should be subdivided into single
working areas, within reach of the power supply cable.
!
Within a short time, the operator will learn how to avoid
unnecessary inconveniences caused by the cable.
g
h
f