RoofScreen Mfg., Inc.
SC3 Frame Kit Installation Guide
Updated 06.13.16
5
S
TEP
3:
I
NSTALL
G
ASKETS AND
B
ASE
A
SSEMBLIES
With all Base Supports installed and roofed in, install the Base Gaskets over the flashings. The gasket strip is self-
adhering and has a removable backing. Peel the backing off and stick the gasket on the outside of the flashing,
flush with the top. The gasket is not meant to be pulled or stretched during installation, however it may be
necessary to stretch it slightly at the end so the ends meet evenly.
After the Gaskets are in place, install a Base Assembly, Part# A10, on each Base Support (see Figure 3). A10
Assemblies are attached with (8) Bolts with Poly Washers, Part# B11. The bolts thread into pre-tapped holes in the
top of the Base Support. Start the bolts by hand, threading each one a few turns to make sure they are not cross-
threaded. Once all 8 bolts are started, tighten the bolts moving in a crisscross pattern similar to tightening lug nuts
on a car wheel.
At this time, do not tighten the large bolt in the RotoLock as shown in Figure 3.
S
TEP
4:
I
NSTALL
H
ORIZON TAL
T
UBES
Locate the horizontal tubes labeled “H”, and Field Connectors Part# C12. Attach the field connectors to the
crimped ends of the tubes with a ½” diameter bolt, nut and lock washer, Part Numbers B13, N10 and W10 (see
Figure 4).
F
IGURE
4
F
IGURE
3
