28
To remove the blockage, proceed as following.
• Switch the appliance off (flip ON/OFF switch to middle position “0”).
• Start the reverse function by flipping the on/off switch to position “2” and hold it in this position for
3 – 5 seconds.
o The juicing screw will rotate the other way round (anti-clockwise) to remove the blockage. When
you let go the switch, the appliance will stop. Then start the juicer on position “1” to check whether
the blockage came lose.
o If required, run the juicer alternately in position “1” and “2” and repeat this procedure 2 – 3 times.
o When the blockage is removed, juicing can be resumed.
In case this action was not able to eliminate the blockage of the juicing screw, the appliance must be
disassembled in order to remove the food residues.
• Switch the appliance off and pull the mains plug.
• Remove the top cover (see “Disassembling the appliance”).
• Now, carefully remove the blockage at the juicing screw with a spoon made of wood or plastic.
• Attach and lock the top cover (see “Assembling the appliance”).
• Prior to connecting the appliance to the mains again, make sure that it is not switched on
unintentionally!
• Switch the appliance on and resume working.
Cleaning and maintenance
ATTENTION: Risk of injuries!
•
Always unplug the appliance before cleaning!
•
Never immerse base unit and mains plug in water or
clean them under running water!
NOTE: An improper or only sporadic cleaning can cause a formation of mould!
TIP:
Highly pigmented foods (e. g. carrots) may stain the appliance’s plastic parts or accessories. Wipe
those parts with some cooking oil before cleaning them.
• Clean appliance and accessory parts immediately after use so that residues will not dry up.
• All accessory parts of the juicer are
not suitable for cleaning in the dishwasher
.
•
ATTENTION
: Do not use any abrasives or solvents or sharp-edged objects!
•
ATTENTION
: Never use a steam jet appliance for cleaning!
Pre-cleaning.
• Shut the closing cap of the juice outlet.
• Switch the appliance on and fill the juice collecting bowl half with warm water (observe the MAX
marking).
• Let the appliance run for about 20 – 30 seconds.
• With the juicing screw running, open the juice outlet and drain off the water into a suitable container.
Switch the appliance off.
