Rommelsbacher CT 2020/IN, Инструкция по эксплуатации

Страница: 34 / 40

34
• By touching the “+“ sensor you can increase the
operating time at 1-minute intervals up to 3 hours
(180 minutes).
• By continuously touching the “+“ sensor you can
increase the operating time in 10-minute intervals.
NOTE: If there is no further activation within
5 seconds after activating the operating time, the
control will switch back to the normal cooking mode
without timer.
• By touching the "-“ sensor, you can reduce the
operating time in 1-minute intervals.
• By continuously touching the “-“ sensor, you can
reduce the operating time in 10-minute intervals.
NOTE: Starting with the “-“ sensor, the display
commences with “3:00” (180 minutes). By touching
this sensor again you can reduce the operating time.
• On the display you see the adjusted operating time e.g. “1:15” (1 hour, 15 minutes). About 5 seconds
after setting the timer, the display switches back to the initial function. When touching the senor
“timer” again, the display shows the active remaining operation time for approximately 5 seconds; now
you can adjust the timer once again. The pilot lamp “Timer” indicates that the operating time is active.
• Once the set time has elapsed there is a short signal tone and the control automatically switches over
to “Standby” mode. The display shows either “H” or “OFF”.
NOTE: A modification of the power or temperature level does not influence the set operating time.
Setting the operating time (timer) – reset function
• Tap the “timer” sensor for 3 seconds for
deactivating the operating time mode.
• Tapping the sensor is confirmed by a signal tone
and the timer display gets reset to the value
“0:00”.
• The setting of the operating time is no longer
active.
NOTE: In this case there will be no automatic switch-
off and the appliance keeps on working.