Inward Folding
Bath Screen
Instruction Manual
H2D6CS
IMportant InForMatIon
•
Toughened glass is completely safe for use in our shower enclosures and bath screens; providing our products are installed according to our
guidelines.
•
It is important to note that the glass must not be mounted or ‘pinched’ in such a way that would cause a stress point to develop in the glass. In
addition, it must not be subject to any sharp impact or severe temperature fluctuation which may also cause a stress point to develop in the glass.
•
Toughened glass is physically and thermally significantly stronger than standard glass. During the toughening process the stresses contained
within any glass are balanced so if in the unlikely event situation any of the above occurs and the glass breaks, the glass will shatter safely into
small thumbnail sized blunt fragments.
Component Check List: Supplied
Description
Quantity
Wall Profile
1
Fixed Panel
1
Moving Panel
1
Bottom Seal
1
Brace Bar Assembly
1
Fixing Kit Components
Description
Quantity
2.5mm Drill Bit
1
9mm Screws
3
40mm Screws
3
Screw Bases
3
Cover Caps
3
Top Cap (Left Hand)
1
Top Cap (Right Hand)
1
Wall Plugs (for brick and block only)
3
Branding Badge (where applicable)
1
4mm Allen Key
1
Equipment Check List: not Supplied
Description
Electric / Battery Drill
6mm Masonry Drill Bit
Bathroom Sealant Gun
Bathroom Sealant
Screwdriver
Spirit Level
Tape Measure
Pencil
Wall Plugs (not supplied)
Stanley Knife / Snips
Please make sure the purchaser/end user
completes and returns the guarantee card
which is enclosed with this product. Failure
to validate the Guarantee will mean only the 1
Year Statutory Guarantee will apply.
CONSUMER GUARANTEE
prE-InStaLLatIon CHECKS
1. Check you have the correct product. Please look at the labels on the side of the product packaging.
2. Check all the product components are in the box and the fixing kits.
3. Unpack your product and handle it with care.
4. Please check the product for defects or damage. once the installation has commenced we cannot accept responsibility for any defects or damage.
5. Please take time to read these instructions prior to installing your product.
6. Before you commence any drilling check there are no hidden electrical cables and/or water cables.
7. No attempt should be made to re-work the toughened safety glass.
8. The installation of the product should be performed by two persons.
9. It is strongly recommended that the walls the product is going to be installed on are vertical.
10. It is strongly recommended the product is fitted on a tiled surface or similar waterproof surface.
11. It is strongly recommended the walls are tiled and grouted before the product is installed.
12. If the walls and/or the tray are not level you will not achieve maximum adjustment of the product.
13. Pictures used are for illustration purposes only, product designs may alter slightly as a result of continuing product development.
14. We do not stipulate where the European Standard Kite Mark should be positioned on the glass when being factory assembled.
15. Please note that some natural misting may occur when you remove this product from its packaging, due to the addition of the glass protection pre-
coating. If this does occur this can easily be removed with a soft, dry cloth.
Ref: H2D6CS- Jan 2016
