Page 8
RS-Divider Curtain
Part No 4801-5176 Rev 01-11-16
the drive pipe, the curtain can be back rolled on to the drive pipe to achieve desired appearance.
6.2
How to back roll the curtain
1.
Back rolling the curtain will make the curtain roll up in the opposite direction and on the opposite side of the
drive pipe.
2.
To back roll the curtain, run the curtain down to the floor. If limits are already set then depress and release both
limit buttons to reset (see section
5.5
).
3.
Continue to roll curtain down (illustration
1
), excess curtain material will build up on floor, until all material has
unrolled from the drive pipe (illustration
2
) and the drive pipe starts to roll the material back on the seam and
starts lifting the panel back up (illustration
3
).
Illustration 1. Illustration 2. Illustration 3.
4.
At this point you will be holding the down button on the switch, but the panel will be going up. To fix this
simply switch the red and black wires on your switch, as described in section
7
.
5.
With the switch operating correctly, reset the limits as described in section
5.5
.
7
Wiring the RS-Divider Curtain
Warning!
All Wiring Should Be In Accordance with National Electrical Codes Or Other Local Codes.
Warning!
Do not wire two or more motors to one SPDT
(single pole double throw switch-NO PARALLEL WIRING).
!
!
