![background image](http://html1.mh-extra.com/html/rollseal/rs-500-series/rs-500-series_troubleshooting-manual_1483767035.webp)
Part No 4801-5158 Rev 1-2017
RS500/600 Series Doors
Page 35
19.2
Egress Bracket Removal
1.
Close the door. If necessary, the door can be closed using “Jog” mode. See your owner’s manual for
more information.
Warning!
Disconnect All Power Sources Before Installing This Equipment. Failure To Disconnect
Power Source Can Result In Property Damage, Serious Injury Or Death!
2.
Locate the door controller and
turn off the power switch on the
left side of the controller.
3.
Remove the door’s head unit cover.
4.
Locate the Egress Bracket where the
Egress Strap comes through the backplate.
See
Diagram 19C
.
5.
If there is not enough slack in the Egress Strap
to remove and replace the bracket, ensure that
the Egress has been properly reset and the D-ring is in the position shown in
Diagram 19A
.
6.
Remove the 4 nuts holding the bracket and 2 wires from the sensor. See
Diagram 19C
and
Diagram 19D
.
Note the placement of the wires on the sensor.
Note: This sensor is used to activate optional buzzer. Not all doors are equipped with wires for this sensor.
19.3
Egress Bracket Installation
1.
Attach the new Egress Bracket with 4
nuts. See Diagrams 1B and 1C.
2.
Attach the 2 wires to the sensor as noted
when removing the Egress Bracket. See
Diagram 19C
and
Diagram 19D
.
Note: This sensor is used to activate optional buzzer.
Not all doors are equipped with wires for this sensor.
3.
Cycle the door up and down in normal operating mode to ensure proper re-setting of the door. Adjust if
necessary. Door should now function normally. If the door does not operate properly, notify tech support of
the manufacturer.
4.
Re-attach the cover.
19.4
Egress Alarm Activation Troubleshooting
If the door alarm is activated when the door closes, ensure that the Egress strap has been properly reset.
If the alarm is still activates, remove the head cover and inspect the back plate roller where the strap comes
into head unit, make sure contact switch is releasing.
!
Sensor
Note Placement
of Wires on
Sensor
Nuts
Nuts
Backplate
Egress
Strap
Nuts
Nuts
Sensor
Содержание RS-500 Series
