6
Rollerdor RD20X2SOM Somfy Rollixo Control Box, Edition 2022/1
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
Alarm Operation
The alarm is triggered for 2 minutes if the door is raised manually.
No movement of the door is possible when the alarm is sounding.
When the alarm sounds, press a button on a remote control memorised in
the receiver to stop it. The alarm can only be stopped with a memorised
remote control.
To activate/deactivate the alarm, simultaneously press the "STOP"
and buttons on the receiver until the 4 indicator lights flash rapidly.
The alarm emits a beep if it has been activated.
ACTIVATING/DEACTIVATING THE ALARM
Alarm Operation Test
Press "STOP" and the Down button on the
receiver simultaneously.
The alarm triggers briefly to indicate that
it is activated.
POSITIONING OF MAGNETS
1
Bring the door down to its final closed/end limit position. If the door lands on floor and stops,
go to point. If the door comes to floor and retracts (bounces back) then see check the detail
below, this happens because the doors safety edge system has been activated;
Q. Are the end blocks sat in a final position that is lower than the floor level?
A. Raise the blocks and build up with packing.
Q. Is there a high point or bump in the floor?
A. Floor needs to be levelled.
2
Once you are happy that the door has been installed within its operating parameters then
we can fit the bottom magnet.
Mark the guide rail at its lowest point to match the arrow indicated on the right of the Transmitter.
Now move the door up out of the way and use the temporary sticky pad to locate the magnet,
now permanently and mechanically fix the magnet with screws provided in place. The magnet
arrows should now be aligned and no more than 10mm apart.
