10
Rollerdor RD20X2SOM Somfy Rollixo Control Box, Edition 2022/1
Key pad
Commissioning (for first use)
1. Open the Digipad with the key
provided.
2. Press the RESET button.
3. Check that the Digipad has been
commissioned by pressing on
one of the keypad buttons. If the
lower indicator light comes on, the
Digipad has been commissioned.
If it does not come on, press the
RESET button again and check that
it has been commissioned.
Press button Prog on the receiver
until the indicator light comes on
permanently.
Enter 6 x 0 on keypad then press the
desired operating button
Changing the main code
By default, the main code is 000000
on a new Digipad.
To change the main code:
1. Enter the main code and confirm
with the SET button.
2. Press the SET button until the
lower light turns on (approximately
7 seconds). The lower light
remains on.
3. Enter the chosen replacement code
(between 4-8 characters) and confirm
with the SET button. The lower light
will turn off & come on again.
4. Enter the code again and confirm
with the SET button.
The lower light will turn off.
The main code is recorded.
Main code forgotten and full reset
The Digipad must be reset: stored
settings cleared, codes and radio
protocol reset to factory settings.
To reset the Digipad:
1. Open the Digipad with the key
provided.
2. Press the ADR button
(approximately 10 seconds). The
upper light will come on when
the button is pressed and then
the 2 lights will flash 7 times. The
Digipad is reset.
3. Close the Digipad.
4. Repeat the full installation
procedure: programming,
changing main code, etc.
WIRELESS KEY PAD
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
