9
| Automate
™
Programming Instructions | FT Tubular Motors
ROLLEASE ACMEDA
SEC
SEC
S
S
5
5
Cycle shade up and down prior to setting limits to settle fabric
When using the Ultra-lock, the bottom limit must be set within the ‘locking zone’. Jog the weightbar down until you hear the locking pin click
into the latch housing.
Once the bottom limit is set, refer to Section 10 to activate Fabric Tension Mode.
After setting limits, motor will automatically exit from initial
set-up mode.
Move shade to the desired highest position by
pressing the
UP
button on controller.
Move shade to the desired lowest position by
pressing the
DOWN
button on controller.
To save upper limit, hold
UP
and
STOP
.
To save lower limit, hold
DOWN
and
STOP
.
Motor Response
Motor Response
IMPORTANT
IMPORTANT (ULTRA-LOCK V2 ONLY)
Initial set-up is complete
IMPORTANT
Approx.
Approx.
4.4 Set Lower Limit
4.3 Set Upper Limit
