Maintenance That Must Be Performed Daily
21
2.Regular Maintenance
B
Open the front cover.
IMPORTANT
Be sure to hold the handle of the front cover and open and close it gently.
C
Secure the paper for the printing test.
Printing tests are used to check that no dot drop-out occurs. Use paper for testing (width 90 mm
(3.54 in.) × length 70 mm (2.76 in.) or more), not the object that will actually be printed on.
MEMO
Secure the media with tape.
Secure the media in place using a substance such as commercially available tape affixed directly to
the flat table. This method can be used for thin paper and other such media that can be secured
with tape only. It can be set anywhere as long as it does not protrude from the top of the flat table.
Be aware that folds or kinks in the paper might hit the interior of the printer and cause damage.
D
Close the front cover.
4.
The height of the object to be printed on is detected automatically.
The height of the object to be printed on is automatically detected, and the print heads are adjusted
to the appropriate height for printing.
Procedure
A
Press [SETUP].
[SETUP] starts to flash.
B
Open the front cover.
C
Press [ ], [
], [UP], or [DOWN] to move the flat table, bringing the highest position of
the print surface into contact with the head gap sensor.
When the head gap sensor reacts, a buzzer goes off.
D
Press [
] to display the screen shown below.
AUTO DETECTION
