Maintenance That Must Be Performed Daily
20
2.Regular Maintenance
B
Press [
] to display the screen shown below.
MENU
SUB MENU
C
Press [
] twice to display the screen shown below.
SET AT SETUP
DISABLE DISABLE
D
Press [ ] or [ ] to select "ENABLE."
SET AT SETUP
DISABLE ENABLE
E
Press [ENTER] to confirm your entry.
2.
Set the lower-right corner of the object to be printed on to the base printing position.
Set the base printing position (home position) at the front right of the print area. This method is
appropriate when the print site is level, and you can clearly specify the print area.
Print area setup can be performed with the front cover open. However, if the front cover is left open
for approximately 40 seconds, the print heads automatically return to the home position. The menu
returns to the previous one. Repeat the procedure.
Procedure
A
Press [ ].
B
Press [
] twice, and then press [ ] once to display the screen shown below.
SET BASE POS.
LOWER R CENTER
C
Press [ ] [ ] to select "LOWER R."
D
Press [ENTER] to confirm your entry.
E
Press [MENU], then [
] to go back to the original screen.
3.
Attach the object to be printed on for the printing test.
Procedure
A
Check that the following screen is displayed.
SETUP MEDIA
If this screen is not displayed, check that nothing has been placed on top of the flat
table, and then hold down [SETUP] for 1 second or more.
The flat table will come forward into a position in which the object to be printed on can be set
up.
