50
Other Tips
Enabling/Disabling the Beep Tone
You can specify whether or not a beep tone will be heard when you touch a valid point on the touch screen.
✱
A
Att tth
he
e ffa
acctto
orry
y sse
ettttiin
ng
g,, tth
he
e b
be
ee
ep
p tto
on
ne
e w
wiillll b
be
e sso
ou
un
nd
de
ed
d..
1.
In the upper right of the screen, touch
triangle
. A drop-down menu appears.
2.
In the drop-down menu, touch
<Beep>
to add a check mark . With this setting, the beep tone will be heard. If you perform the
same procedure once again, the check mark will be cleared and the beep tone will no longer be heard.
Changes you make to the System function settings are only temporary—they will be discarded as soon as the power is turned off. If you
want to keep any changes you’ve made in the system settings, you must save them in internal memory.
3.
Press
[MODE]
. The
V-SYNTH MODE MENU
window appears.
4.
Touch
<SYSTEM>
. The
SYSTEM Com Master
screen appears.
5.
In the
Powerup Mode area
, select the
<Last Set>
tab.
6.
Touch
<Write>
, located in the lower right of the screen.
Adjusting the Sensitivity of the D Beam Controller
Perform this adjustment if the D Beam controller is functioning incorrectly, such as responding even though you have not operated it.
1.
Press
[MODE]
. The
V-SYNTH MODE MENU
window appears.
2.
Touch
<CALIBRATION>
. The
CALIBRATION MENU
screen appears.
3.
In the
CALIBRATION MENU
screen, touch
<D BEAM>
. The
D Beam CALIBRATION
screen appears. When you place your hand
over the D Beam controller, the “L” or “R” level meter in the screen will move upward or downward.
4.
First specify the location at which the D Beam controller will begin responding (i.e.,
the minimum value). Move your hand toward the D Beam controller, and touch
<Min>
at the point where you want the controller to begin responding.
5.
Next specify the location at which the D Beam controller will reach the peak (i.e.,
the maximum value). Continue moving your hand toward the D Beam controller, and
touch
<Max>
at the point where you want the peak response to occur.
6.
While watching the level meter in the screen, raise and lower your hand to check
the response of the D Beam controller.
7.
If you are satisfied with the response, touch
<OK>
. The sensitivity of the D Beam
controller will be calibrated.
Changes you make to the System function settings are only temporary—they will be discarded as soon as the power is turned off. If you
want to keep any changes you’ve made in the system settings, you must save them in internal memory.
8.
Press
[MODE]
. The
V-SYNTH MODE MENU
window appears.
9.
Touch
<SYSTEM>
. The
SYSTEM MENU
screen appears.
10.
Touch
<Controller>
button at the bottom of the screen, then touch
<D beam>
tab in the left of the screen.
This sets the D Beam Controller’s sensitivity. Sens L is the left side. The higher the value
set, the more readily the D Beam Controller goes into effect. Normally you will leave this
at “100.”
