®
Switching the power on and off
18
r
FR-7x V-Accordion
Switching the power on and off
The power-on procedure depends on whether you are
using a battery pack or the FBC-7 Foot Pedal/DC Power/
Battery Charger Unit.
■
Important notes
• Before connecting the FR-7x to an amplification sys-
tem, be sure to switch off both the FR-7x and the
external device.
• Connect the FR-7x’s OUTPUT sockets to the line
input(s) of your amplifier or mixer.
• After establishing the connections, first switch on the
FR-7x, then the amplifier or mixer.
If you are using the battery pack (without the
FBC-7)
Note:
Only use the battery pack that either came with your
FR-7x or that you purchased from your Roland dealer. Using
other batteries can severely damage the FR-7x or FBC-7.
Roland assumes no responsibility for damages caused by bat-
teries that have not been explicitly approved. Such damages
are not covered by Roland’s warranty regulations.
Note:
When operating on battery power the main page dis-
plays a battery icon that informs you about the remaining
power (three bars means the battery pack is fully charged). The
message “LOW BATTERY. PLEASE RECHARGE!” will be displayed
when battery power gets too low. Replace or recharge the bat-
tery pack as soon as possible (see p. 59).
■
Turning the power on
(1) Turn the
[VOLUME]
knob all the way to the left to
minimize the volume.
(2) Press the FR-7’s
[POWER]
button to switch it on (it
lights).
(3) Adjust the volume to an appropriate level.
■
Turning the power off
(1) Turn the
[VOLUME]
knob all the way to the left to
minimize the volume.
(2) Press the
[POWER]
button again so that it goes
dark.
Note:
Expected battery life under continuous use: Ni-MH:
8 hours. This figure will vary depending on the actual con-
ditions of use.
If the FR-7x is connected to the FBC-7
Once the connections have been completed, turn on the
power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other
devices.
■
Turning the power on
(1) Connect the FR-7x to the FBC-7 using the supplied
19-pin cable (see p. 16). Also connect the FBC-7 to
a wall outlet.
(2) Press the FBC-7’s
[POWER¥ON]
button to switch it
on.
The POWER ON indicator on the FBC-7’s top panel
lights red.
(3) Turn the FR-7x’s
[VOLUME]
knob all the way to the
left to minimize the volume.
(4) Press the FR-7x’s
[POWER]
button (it lights) to
switch it on.
The
icon in the display means that the FR-7x is
powered by the FBC-7.
(5) If connected, switch on your amplification system.
(6) Adjust the volume to an appropriate level.
Note:
This unit is equipped with a protection circuit. A
brief interval (a few seconds) after power up is required
before the unit will operate normally.
FR-7x GB.book Page 18 Tuesday, August 25, 2009 10:58 AM
Содержание V-Accordion FR-7X
Страница 1: ...r Owner s Manual FR 7x GB book Page 1 Tuesday August 25 2009 10 58 AM...
Страница 138: ...138 rFR 7x V Accordion For China For China FR 7x GB book Page 138 Tuesday August 25 2009 10 58 AM...
Страница 140: ...R 602 00 0346 01 RES 738 09 FR 7x Owner s Manual E FR 7x GB book Page 140 Tuesday August 25 2009 10 58 AM...