Rohm KZS-P, Перевод оригинального руководства по эксплуатации

Страница: 11 / 43

Safety | 2
KZS-P_KZS-PG 11 / 43
▪ assembly of the centric clamp and individual parts with incorrect tighten-
ing torque (see Checking the Tightness of Screw Connections
[
}
35] ).
2.3 Obligations of the Owner
Before all work on and with the centric clamp, the operator is to ensure:
▪ that the operating instructions are available to the responsible personnel.
▪ that the responsible personnel are sufficiently qualified for their work.
◦ This applies in particular to assembly, maintenance and repair.
▪ that the responsible personnel have read and understood the operating
instructions.
◦ RÖHM GmbH recommends that this be documented in a suitable form.
▪ that all safety equipment is correctly mounted and operational.
◦ Safety equipment must never be by-passed, manipulated or shut down.
▪ that the centric clamp is in perfect working order.
▪ that all damaged and defective parts are replaced immediately.
2.4 Qualification of Operating and Specialist Personnel
Trained personnel
Trained personnel have been instructed in correct handling and possible
dangers when using the centric clamp. In particular, the personnel must have
been instructed in the safety equipment.
Qualified personnel
Personnel without experience of handling a centric clamp are exposed to in-
creased risks of injury in the event of incorrect conduct, especially during as-
sembly and maintenance work, due to the clamping movements and forces.
Therefore, the centric clamp may only be assembled, maintained and serviced
by persons who have received special training or instruction for this purpose
or who have extensive experience. The qualified personnel must be able to
read and understand the displays and to act accordingly. The qualified per-
sonnel must have read and understood this operating manual.
In particular, qualified personnel are:
▪ Mechanics
Work on the mechanical equipment may only be carried out by a trained
mechanic or by personnel under the direction and supervision of a trained
mechanic. Work on gas, pneumatic and hydraulic equipment may only be car-
ried out by mechanics trained for this purpose.