Rohde TC 304, Инструкция по эксплуатации

Страница: 20 / 72

88
Temperature for 1st switching point: Tmp1
The kiln heats up at the previously set heating rate (Rmp1) until reaching the tem-
perature set for the 1st switching point. By default, the temperature is entered in
degrees Celsius per hour.
Push the
X
or
W
key until the “Tmp1” LED indicator in the 1st dwell tem-
perature program section flashes. The display shows the value that has
been stored. Use the
S
or
T
key to enter a value between 20 and 1320°C.
Heating to end temperature: Rmp2
The kiln heats up at the rate set. By default, the rate is entered in degrees Celsius
per hour.
Push the
X
or
W
key until the “Rmp2” LED indicator in the 2nd heating ramp
program section flashes. The display shows the value that has been stored.
Use the
S
or
T
key to enter a value between 1 and 999°C/h or SKIP (heating
at full power).
Temperature for end temperature: Tmp2
The kiln heats up at the rate set until reaching the first dwell temperature. By default,
the rate is entered in degrees Celsius per hour.
Push the
X
or
W
key until the “Tmp2” LED indicator in the end temperature
program section flashes. The display shows the value that has been stored.
Use the
S
or
T
key to enter a value between 20 and 1320°C.
Dwell time at end temperature: t2
The kiln holds the end temperature for the time set. The dwell time ensures an even
heating of the fired products inside the kiln
Push the
X
or
W
key until the “t2” LED indicator in the dwell time at end
temperature program section flashes. The display shows the value that has
been stored. Use the
S
or
T
key to enter a value between 0.00 and 9.59
(hours.minutes).
Cooling or end of program: Rmp3
At the end of the dwell time, the kiln cools down either controlled (e.g. 200°C/h) or
uncontrolled (= SKIP). At 150 °C, the controller stops the temperature control and
the display shows “End” to indicate the end of firing.
Push the
X
or
W
key until the “Rmp3” LED indicator in the cooling or end
of program section flashes. The display shows the value that has been
stored.