Rohde TC 304, Инструкция по эксплуатации

Страница: 16 / 72

44
Mounting the TC 304 Control Unit
Mounting the control unit on the wall
Choose a safe and easily accessible position on a wall next to the kiln to mount the
control unit.
First screw the two knurled screws into the holes indicated on the back of the
controller. They will be used later to fasten the controller in the fixing device.
Mount the holding panel of the TC 304 control unit
using the three dowels and three screws, with one
fixing hole pointing upwards and the other two poin-
ting downwards.
Make sure that the transparent protective foil is
correctly aligned!
Now the controller can be plugged into the fixing
device from above. You might have to loosen the
knurled screws on the controller.
Mounting the control unit on the KE controller panel
Place the frontloader controller panel in a position that will allow the star-shaped
knob to be turned until it locks into the position indicated. When the panel is fixed,
you can start mounting the controller on the panel.
Mount the holding bar of the TC 304 control unit using the three screws, nuts and
washers, with one fixing hole pointing upwards and the other two pointing down-
wards.
Make sure that the transparent protective foil is correctly aligned!
First screw the two knurled screws into the holes indicated on the back of the
controller.
Now the controller can be plugged into the fixing device from above. You might
have to loosen the knurled screws on the controller.