Rohde ELS 1000 S, Оригинальная инструкция по эксплуатации

Страница: 132 / 138

131 / 136 - EN -
15. Decommissioning
15.1. General information
When decommissioning and storing the kiln, observe the country-specific laws, regulations and standards.
⇒ It is recommended that the kiln be decommissioned by a qualified specialist company.
15.2. Disassembly
DANGER
Risk of serious personal injury and property damage and even death caused by work on the
kiln by unqualified personnel.
⇒ Only have work on the kiln carried out by qualified specialists who have been specially
trained and authorised.
WARNING
Risk of serious personal injury or property damage caused by an incorrectly dismantled kiln!
⇒
The kiln should only be dismantled by qualified personnel.
⇒
Put the kiln out of operation (pull out the power plug/isolate it electrically).
⇒ Only have qualified electricians disconnect the kiln wiring.
⇒ Fasten moving parts (e.g., kiln door, ELS kiln floor).
⇒
When dismantling the kiln, only lift it using the lifting or transport points provided.
⇒
Pay attention to the centre of gravity of the kiln and use transport locks.
⇒ When dismantling, make sure that the permissible loads are not exceeded.
⇒
Prohibit unauthorised access during the entire dismantling work.
⇒
It is recommended that the kiln be disassembled by a qualified specialist company.
15.3. Disposal
The product must be properly disposed of at the end of its
service life.
Electrical equipment must never be disposed of with general or
household waste.
Electrical devices must be collected and disposed of separately
for proper treatment. By doing this, you help with the recovery,
recycling and reuse of raw materials.
To protect the environment, components and packaging that are
easy to dispose of are predominantly used.
When disposing of the kiln, observe the country-specific laws,
regulations and standards.
⇒
It is recommended that the kiln be disposed of by a qualified
specialist company.