Rohde & Schwarz DVS SpycerBox Flex, Руководство по оборудованию, Страница: 48 / 76

5-6
SpycerBox Ultra/Flex Hardware Guide
Figure 5-2: Pulling out the lever
This takes the hard disk installed in the disk carrier out of the system’s
interfaces inside.

Once the interface connections inside the system are severed, you
can pull the disk carrier out of the system.
Now the hard disk is removed from the system and it has to be replaced
in the next step.
Step 2: Replacing the Hard Disk
To replace the hard disk do the following:

Unscrew the screws that fix the hard disk to the disk carrier.

Exchange the broken disk with a new one and assemble it in the
disk carrier with the screws.
After that the hard disk is replaced and the disk carrier with the new
disk has to be reassembled in the system.
Step 3: Reassembling the Hard Disk
After replacing the hard disk, the disk carrier with the new disk has to
be reassembled in the system. For this perform the following:

Slide the disk carrier back into its shaft at the disk array.

Push the disk carrier completely back into the shaft by applying
pressure to the disk carrier directly (i.e. do not use the lever to push
the carrier). Move it until you feel the resistance of the hard disk
interface inside the system and until the lever retracts by itself from
the pushing.
Significant environmental changes, for example, altitude,
voltage, temperature, shock, vibration, etc., can damage a
hard disk. Therefore, handle hard disks with great care.
It is best to use the same brand and type of hard disk again.
Otherwise a loss of performance might occur.
It is important that you do not use the lever to insert the
disk carrier. Apply an even pressure only to the carrier di-
rectly until the lever moves back by itself.
SpycerBox Flex and system disk array: