Rohde & Schwarz DVS SpycerBox Flex, Руководство по оборудованию, Страница: 47 / 76

5-5
2
1
3
5
4
Maintenance
I
A
5.1.3 Replacing a Hard Disk
As soon as the broken hard disk has been identified (see section “Iden-
tifying a Broken Hard Disk” on page 5-4), it can be replaced easily. The
replacement of a broken hard disk can be divided into three steps:
1. Removing the hard disk from the system.
2. Replacing the hard disk.
3. Reassembling it into the system.
All steps are explained in the following.
Step 1: Removing the Hard Disk
The hard disks that are accessible at the front and rear of the system
are connected to the system with the help of disk carriers. They can be
removed easily, even when the system is running (hot-swappable).
To remove a hard disk from the system perform the following:

If appropriate, stop all accesses to the hard disks of your system,
for example, by exiting software and severing the network connec-
tions.

Lift the faceplate of the system (see section “Faceplate” on
page 2-5).

Then, unlatch the disk carrier of the defective hard disk by pressing
the opener of the disk carrier (1).
This will cause the lever to come out of the disk carrier so that it pro-
trudes from the rest of the disk carriers.

Take the lever and turn it in its hinge (2) until it cannot be moved
further:
Before replacing a hard disk you have to gather the log files of
the RAID controller. If you know how to do this you may pro-
ceed on your own. If not, please contact the DVS service de-
partment first.
For an overview of a disk carrier as well as further information
about it see section “Hard Disk Array” on page 2-6 and section
“System Disk Array” on page 2-12.
SpycerBox Ultra: