Rogers WG6, Руководство по сборке, деталям и эксплуатации

Страница: 9 / 15

Rogers Sprayers Inc. Toll Free 1-888-975-8294 www.rogerssprayers.com 9
Operation
Maintenance
Approximate Weight of Units
Drawings and Replacement Parts
Ceramic insert tips are supplied with the Windfoil WG series ; it can also use stainless steel, brass or plastic insert
tips that give an actual 80º spray pattern.
Attach a supply hose to the camlock fitting on the control valve, located on the sprayer handle. The supply pressure
of the fluid should be between 40 & 60 psi (3-4 bar). A rough estimate due to losses in the system is that when you
have 45psi (3.2 bar)at the handle, you probably have 40 psi (3 bar) at the tips. Each of the balls in the spray monitor
should raise to an equal level as the flow increases. If they are not equal the lower ball(s) indicated tips that are
plugged or partially plugged. Check and clean the appropriate tip(s). If the balls are right at the top, the flow rate is
too high for them. Replace them with the required balls for the tips (see the flow monitor page).
Test the unit using clear water on a firm surface such as asphalt or concrete before using spray solution. This will
illustrate the effectiveness of the individual spray patterns.
Cleaning and flushing with clear water after using.
Do not leave water in the unit at freezing temperatures. When storing the sprayer at freezing temperatures, run some
windshield washer antifreeze through to prevent ice damage in the plastic parts.
Avoid storage of your sprayer in direct sunlight for prolonged periods. Certain plastic parts on the
Windfoil WG are not
UV resistant.
Keep the unit covered or stored indoors.
MODEL
Weight
Lbs
Weight
Kg
WG3 53.6 24.3
WG4 55.4 25.1
WG6 61.4 27.9
See the following pages for a parts breakdown and accessories for your unit.