Rogers WG6, Руководство по сборке, деталям и эксплуатации

Страница: 8 / 15

Rogers Sprayers Inc. Toll Free 1-888-975-8294 www.rogerssprayers.com 8
Follow the same safety precautions during cleaning as for applications. Use a respirator, rubber gloves, or other
protective gear as may be directed by label instructions.
If a nozzle becomes blocked, turn the sprayer off. Note that the spray lines could still be pressurized therefore prior to
removing the cap on the nozzle body, proper safety equipment should be worn, (ie gloves, eye protection, etc).
Sunshine
Many plastic sprayer parts are degraded by ultra violet light, especially the nozzle flow indicators. Store the sprayer in
the shade to extend the length of service.
Winterizing
After the sprayer is thoroughly cleaned, put 2-5 gallons (7-19 litres) of rust inhibitor or antifreeze in the tank prior to the
final flushing to help prevent corrosion. As the water is pumped from the sprayer, the antifreeze will leave a protective
coating on the inside of the tank, pump, and plumbing. Remove nozzle tips, screens and no-drip valves (if used) and
store them in a can of light oil such as diesel fuel or kerosene to prevent corrosion. Close nozzle openings with tape to
prevent dirt, insects, mice, or other contaminants from entering.
During the final cleaning, completely check the sprayer. Look at the hoses, clamps, connections, nozzle tips, and
screens for needed replacements. Store the sprayer in a reasonably clean and dry building.
Assembly
There is more than one way to successfully assemble your Windfoil sprayer. Following the outlined steps will help to
ensure a simple, trouble free assembly. All assembly references to left and right are referring to the sprayer left and right
when facing the rear of the sprayer. Two people are required to remove sprayer from carton, or for any general lifting of
the equipment (ie lifting into transport mount).
Front Wheel Installation
See General Assembly drawing for layout.
Locate four, (4) holes on the front of the sprayer, two, (2) to each side of the Windfoil logo.
Bolt the front wheel mount to these holes.
Slide front castor fork through castor bushing and insert cotter pins to secure.
Grease castor prior to use if required.
Install all three poly wheels.
Handle attachment
Place the handle in position so that the tube is on the outside of the mounting plates.
Bolt handle into place.
Orient the handle so that the hose is to the right.
Hose attachment
Attach hose from flow indicator to valve on handle with gear clamps as provided
Last Check
Recheck all assembled parts for completeness and secure connections.
Locate the grease nipple on the front caster wheel and grease it.
Your sprayer is now ready for a wet test, to ensure complete operation.