Rogers WG6, Руководство по сборке, деталям и эксплуатации

Страница: 3 / 15

Rogers Sprayers Inc. Toll Free 1-888-975-8294 www.rogerssprayers.com 3
Many people die or suffer serious injury in job related accidents every year due to carelessness. Know your machinery
and be aware of potential hazards. Put safety first in all your operations.
Review all instructions and procedures outlined in this manual annually. Every operator must familiarize himself with the
operating instructions of the sprayer.
Operational Safety
Shut down sprayer and power unit and wait for all parts to stop before adjusting, cleaning, or lubricating the power unit or
sprayer.
Before spraying a field familiarize yourself with any rocks, debris, trees, ditches or gullies that may be potentially
dangerous. Plan the spraying route to avoid these hazards.
Spray only chemicals that unit was designed for, (ie turf application). Do not use products for which unit was not
designed, (ie PAINT, sealants, cleaning fluids, dust inhibitors, ice surfaces).
Minimize Chemical Drift
The
Windfoil sprayer was designed in a wind tunnel to control air flow around and behind the sprayer minimizing drift to
allow safer spraying in windy conditions.
Drift can blow off a field after it has been sprayed, especially in high winds. Reasonable caution should be taken in order
to spray effectively and safely.
For maximum drift control, keep curtain in contact with the ground to ensure a seal to it. Drift control of the
Windfoil is less effective when the wind blows the curtain off the crop canopy breaking the seal between the
curtain and the crop.
Application Tips
Always use clean filtered water in the sprayer tank.
Your
Windfoil Drift Containment Spray System (DCSS) comes standard with ceramic insert tips. These tips are
considered by most to be the best in the industry for wear resistance and spray pattern coefficient of variation. Please
contact your manufacturer for various sizes of tips available for your machine.
Ensure that the pressure on the supply end of the hose used on hose reels is sufficient to deliver the proper pressure at
the hand unit on the delivery end of the hose.
Check the flow rate from all nozzles using the capacity calibration technique; see the Calibration section for tables and
instructions. Use clean filtered water for all calibration testing. Adjust the sprayer pressure to get the proper flow rate.
The flow meters are not accurate enough in absolute terms to be used as a flow meter. In relative terms they are very
accurate.
Safety Safety
General Spraying Information
Caution: Conventional tips are rated at 40 psi (3 bar), for example a 8004 tip at 40 psi (3 bar) delivers 0.4 US
gal/min (1.5 litres/min) . Only conventional 80° tips are recommended for the
Windfoil WG series. Wider
angle tips (110°) have a wider pattern than 80° and will hit the curtain at the ends of the boom and are