Roger PRT12LT, Руководство по эксплуатации

Страница: 8 / 17

PRTxxLT series readers Operating Manual.doc 2019-01-29
8/17
* A 1010
# B 1011
4 . I
N S T A L L A T I O N
G
U I D E L I N E S
 Reader should be installed in such a way to ensure physical access to the connection cable
and/or screw terminals.
 A new factory delivered unit is configured for RACS address ID=0
 The reader should be mounted near the supervised door on a vertical piece of supporting
structure
 Disconnect power supply before making any electrical connections
 Be aware that when installing the reader directly on the metal type surface card reading
distance will deteriorate
 For installations on a metal surface you can place a non-metallic 10 mm thick spacer (a
plastic/plaster plate etc.) between the reader and the supporting structure
 For installations with two readers to be mounted on the opposite sides of the same wall and
aligned along the same geometrical axis, place a metal plate between them and make sure
none of two readers has direct contact with it (allow min. 10 mm space)
 For best results mount the proximity readers at least 0.5 m apart
 With its relatively weak electromagnetic field generation, reader should not cause any
harmful interference to operation of other equipment. However, its card reading
performance can be affected by other interference generating devices, esp. radio waves
emitting equipment or CRT computer monitors
 If card reading performance of the reader deteriorates (e.g. reduced reading range or
incorrect readings) consider reinstallation in a new location.
Screw terminals and wires
Wire
Color Label Function
Green CLK DATA 0 line for Wiegand, CLOCK for Magstripe and RACS
Brown DTA DATA 1 line for Wiegand, DATA for Magstripe and RACS
Yellow IN1 Input line; in Wiegand and Magstripe formats this line by default controls LED
OPEN
. In RACS format the line can be used to block card reading and PIN
entering. Line is active when shorted to ground
Pink IN2 Input line; in Wiegand and Magstripe formats this line by default controls
internal buzzer of the reader. Line is active when shorted to ground
Red +12V Supply input plus
Blue GND Supply input minus
Grey TAMP Tamper switch contacts, normally closed, isolated, 24V/50mA. Contacts became
open when unit is detached from the place of installation or upper part of
enclosure is open
White