Roger PRT12LT, Руководство по эксплуатации

Страница: 3 / 17

PRTxxLT series readers Operating Manual.doc 2019-01-29
3/17
For Wiegand:
 F1=C hex
 F2=D hex
For Magstripe:
 F1=FF FF FF FF BC hex (1099511627708 dec)
 F2=FF FF FF FF BD hex (1099511627709 dec)
2.4. O
PERATING
M
ODES
The PRTxxLT offers following data transmission formats:
 Wiegand 26bit
 Wiegand 32bit, normal mode (from MSB to LSB)
 Wiegand 32bit, reverse order (from LSB to MSB)
 Wiegand 34bit
 Wiegand 42bit
 Wiegand 66bit
 Magstripe (ABA Track II emulation, also called Clock & Data)
 RACS address ID0..3 (addressable format for communication with Roger controllers)
Wiegand Formats
When using Wiegand transmission format, data is
transmitted to the host via CLK and DTA lines. Depending
on the selected version of the transmission format, the
reader can send 26, 32, 34, 42 or 66 bits to the host. PIN
can be transmitted as a whole (when # key is pressed )
or each digit separately – see section 3.2.
In
Wiegand format all LED indicators and buzzer of the
reader can be controlled by IN1 and IN2 inputs. Both
inputs (IN1 and IN2) are triggered by shorting them to
supply minus. Input functions can be configured within
Memory Reset procedure. In addition, whenever card is
read or PIN is entered reader activates momentary LED
SYSTEM and buzzer.
Wiegand transmission is unidirectional and data is sent to
host device without receipt confirmation.
Note: For card codes which require more bits than the
number of bits available in the selected data transmission format, reader omits the most significant
bits (MSB-s) of the card code. As a result transmission from a reader is not the same as full card
code.
Magstripe Formats
When using Magstripe transmission format, data is
transmitted to the host via CLK and DTA lines. In
Magstripe format all LED indicators and buzzer of the
reader can be controlled by IN1 and IN2 inputs. Both
inputs (IN1 and IN2) are triggered by shorting them to
supply minus. Input functions can be configured within
Memory Reset procedure. In addition, whenever card is
read or PIN is entered reader activates momentary LED
SYSTEM and buzzer.
Card code is always transmitted as a whole number (no
digits are lost) while PIN can be transmitted as a whole
(when # key is pressed ) or each digit separately – see
section 3.2.