Roger PRT12EM, Инструкция по установке и программированию

Страница: 6 / 59

PRT-EM Series Readers fv 1.29 and 2.29 Rev. J.doc 2012-01-05
Page 6 from 59
2 . I
M P O R T A N T
N
O T E S
Note: The PRT-EM term refers to any type of access terminal from PRTxxEM series readers. It is
clearly indicated when given information refers solely to specific device and is not valid for entire
series.
The PRT-EM reader can be configured for several operating modes however the factory shipped
unit is pre-configured for RACS address ID=0 .
The PRT-EM reader can be programmed in following ways:
 Manually from the keypad located on primary reader (when available)
 Manually from the keypad located on secondary reader (when available)
 Manually by multiple readings of the so called Programming Card
 Remotely from PC computer with RARC program
If the reader is dedicated for operation in standalone mode (offline operation) and has to be
programmed manually, it is necessary to program two special users into the reader: MASTER and
INSTALLER, each of them can have card and/or PIN.
Any proximity card or tag can be programmed as MASTER or INSTALLER card. The same card can
be programmed as MASTER or INSTALLER card to multiple readers. Whenever required (e.g. when
stolen or lost) the new MASTER and INSTALLER cards can be programmed into given unit. No
proximity cards are shipped with factory new unit - if necessary, installer must arrange and enroll
them to the reader by himself.
Note: If after power up the LED SYSTEM is lit it means that contents of reader’s memory is
corrupted. In this case reader must be initialized and programmed anew.
2.1. C
OMPATIBILITY
R
ULES
Always check the firmware and hardware version for which manual is dedicated. Using wrong
version of manual may cause that device will not behave as described in document.
Also, when you upgrade firmware in the reader assure that the new firmware is dedicated for given
type of reader (it must be clearly stated that given firmware is dedicated for given type of product
you have). Once the firmware is uploaded assure adequate manual for the upgraded device.
2.2. A
BOUT
T
HIS
M
ANUAL
This manual is dedicated for all versions of PRT-EM readers: with keypad and without keypad. No
matter if the PRT-EM readers have built-in keypad or not they represents the same logical
functionality. The only difference between various types of PRT-EM series readers is limited to
theirs mechanical construction, environment in which they can be installed and keypad which exist
in limited number of PRT-EM readers. As the result of these the same configuration settings can be
used to program various members of PRT-EM readers; also using RARC program configuration
settings can be transferred (copied) between different members of PRT-EM family.
Theoretically, it is possible to program and use PIN codes and other functions related with keypad
on PRT-EM readers which are not physically equipped with keypad however this has practical sense
only when PRT-EM reader without keypad operates in
Full Standalone Mode with another
(second) PRT-EM reader which has built-in keypad. In such scenario users can utilize keypad
functions (including PIN codes) on this second (slave) reader.
When PIN codes are programmed into reader without keypad it is obvious that they cannot be used
on this individual reader however still they will exist in configuration settings of this particular unit
and can be transferred from the reader to PC and then to another PRT-EM unit.