MCT64E MCT66E Operating Manual
09.07.2020
2/15
1.
D
ESIGN AND APPLICATION
MCT64E-IO and MCT66E-IO are access terminals dedicated to RACS 5 system. Depending on their
versions, devices enable identification of users by PINs and/or EM125kHz (UNIQUE) proximity cards.
Terminals are connected to access controller through RS485 interface. Devices can be installed in outdoor
locations without any additional protection measures.
Characteristics
RACS 5 system access terminal
EM125kHz (UNIQUE) proximity cards
3 LEDs indicators
Buzzer
Silicone keypad with backlight*
3 NO/NC inputs
2 transistor outputs
1 relay output
RS485 interface
Tamper protection
Outdoor environment
Screw terminals
* only MCT64E-IO
Power supply
The terminal requires power supply voltage in range of 11-15VDC. It can be supplied from MCX2D/MCX4D
expander of MC16-PAC-KIT, from MC16 access controller (e.g. TML output) or from dedicated power
supply unit. The supply wire diameter must be selected in such way that the voltage drop between supply
output and the device would be lower than 1V. The proper wire diameter is especially critical when device is
located in long distance from the supply source. In such a case the use of dedicated power supply unit
located close to the device should be considered. When separate power supply unit is used then its minus
should be connected to controller’s GND by means of signal wire with any diameter. It is recommended to
use UTP cable for connection of device to controller. The table below shows maximal UTP cable lengths in
relation to the number of wires used for power supply.
Table 1. Power supply cabling
Number of UTP wire pairs for power supply
Maximal length of power supply cable
1
150m
2
300m
3
450m
4
600m
