HRT82MF Installation Guide Rev.B
2015-08-13
© 2015 ROGER sp.j. All rights reserved.
9/12
Communication
timeout
0..255
The device signals communication failure when selected
timeout [0.5s] elapses. When 0 is selected then failure is
not signalled at all.
Optical Signalization
Keypad Backlight
Level
0..100%
Keypad backlight level
Backlight Animation On, Off
When activated, panel will temporary switch on keypad full
backlight when card is read or key is pressed and dim the
backlight afterwards.
Backlight Dim
On, Off
When activated, panel will temporary switch off keypad
backlight when card is read or key is pressed.
Acoustic Signalization
Buzzer loudness
level
0..100%
Buzzer loudness level. Buzzer is switched off when 0 level is
selected
Card Read
Confirmation Signal
on Buzzer
Yes, No
When activated, card reading is signalled with buzzer.
Key Press
Confirmation Signal
On Buzzer
Yes, No
When activated, button pressing is signalled with buzzer.
CSN Number Settings
CSN Number of
Bytes
0..8
The parameter specifies how many bytes of read only Chip
Serial Number (CSN) is used in UID card number.
Mifare Classic Settings
Card number
CSN, MSN.
SSN
When CNS is selected then UID includes only this number.
When MSN or SSN is selected then it is possible to use
administrator defined UID. It is also possible to define UID
consisting partially of CSN and MSN or SSN.
Format
BIN, HEX
ASCII
Card number format. When BIN is selected then bytes from
card correspond to UID number. When HEX ASCII is
selected then bytes from card correspond to UID in ASCII
hexadecimal format.
LSB
0..15
The location of MSN or SSN first byte.
MSB
0..15
The location of MSN or SSN last byte.
Sector ID
0..39
Sector number with SSN. For MSN this setting is disabled.
AID
0000..FFFF
AID number in MAD sector which defines sector with MSN.
For SSN this setting is disabled.
Block ID
0..14
Block number in the sector with MSN or SSN.
Key Type
A, B , Roger
Type of key used for reading MSN or SSN.
Key
00000000000..
FFFFFFFFFFFF
Six bytes key used for reading MSN or SSN.
Advanced Settings
Stop Card/PIN
Reading When
Buffer is Full
yes, no
When activated, Card/PIN reading is stopped until buffer is
empty.
