HRT82MF Installation Guide Rev.B
2015-08-13
© 2015 ROGER sp.j. All rights reserved.
5/12
Touch button
HRT82MF reader is equipped with touch button dedicated to entry bell. However in case of both
HRC and PR821-CH controllers the function is programmable and the button can be used for
various purposes.
3.5 Wall mounting and installation guidelines
HRT82MF consists of front panel and base which are factory assembled and require manual
disassembly prior to installation according to fig. 4.
Installation guidelines
Install device on wall far from sources of heat and moisture
It is recommended to install device on Ø60mm flush mounting box
Front panel and base must be properly oriented in order to ensure functioning of tamper
resistance.
All electric connections must be made with power supply switched off
Run connection wires through hole in device base and then connect wires to screw terminals
If device and controller are supplied from different power supply units then it is necessary
connect GND terminals of both devices
Front panel can be regularly cleaned with wet cloth and mild detergent. Do not clean by means
of abrasive materials and strong cleaners like alcohols, solvents, etc.
Damages resulting from improper maintenance or use are not covered by warranty
