Roger CPR32-SE v3.0, Руководство пользователя

Страница: 3 / 15

CPR32-SE v3.0 User Manual Rev.A.doc 2017-04-14
3/15
1. I
NTRODUCTION
1.1 This manual
This manual contains minimum information that is necessary to properly install CPR32-SE v3.0
network controller within RACS 4 access control system. Full functional description of RACS 4
system and PR Master software is specified in following documents which are available at
www.roger.pl :
 Functional description of PRxx2 series controllers
 Functional description of PRxx1 series controllers
 PR Master User manual
Due to hardware differences the previous version of CPR i.e. CPR32-SE v2.0 is described in
dedicated manual.
2. D
ESCRIPTION AND
S
PECIFICATION
CPR32-SE is optional network controller used in RACS 4 access control system equipped with PRxx1
series and PRxx2 series controllers. The network controller enables enhancement of RACS 4 access
control system with following functionalities:
 events recording in central memory buffer
 configuration of antipassback zones (Global APB) in access control system
 concurrent arming/disarming of access controllers within particular Alarm Zone
 configuration of schedules and calendars (concerns PRxx1 series controllers)
The network controller is equipped with RS485 port which is used for direct communication with
access controllers and for communication with computer (PR Master software) using communication
interface (e.g. UT-2USB). Events from access control system are stored in internal memory buffer
(max. 240 000 events).
Note: The CPR32-NET v3.0 requires PR Master software in version 4.5.20 or newer.
Table 1. Specification
Supply voltage Nominal 18VAC, min./max. range 17-22VAC
Nominal 12VDC, min./max. range 10-15VDC
Nominal 24VDC, min./max. range 22-26VDC
Backup battery 13.8V/7Ah, charging current app. 300mA
Average current
consumption 100 mA (excluding load points connected to AUX and/or TML outputs)
Inputs Eight (IN1..IN8) NO/NC inputs, electrically biased to +12V via 15kΩ
resistor, triggering level app. 3.5V
Relay outputs Two (REL1,REL2) relay outputs with single NO/NC contact, 30V/1.5A
(REL1) and 230VAC/5A (REL2)
Transistor outputs Four (IO1,IO2,CLK,DTA) open collector outputs, 15VDC/1A
Power supply outputs Two power supply outputs: 12VDC/0.2A (TML) and 12VDC/1A (AUX)
Distances Between CPR and and communication interface (RS485): max. 1200m
Environmental class
(acc. to EN 50131-1)
Class I, indoor general conditions, temperature: +5°C to +40°C, relative
humidity: 10 to 95% (no condensation)
IP code IP20
Dimensions HxWxD 80 x 115 x 28mm