Rockwell RK7241S, Руководство пользователя

Страница: 20 / 56

Jobsite table saw with laser eNG
20
oPtioNal aCCessories:
1. FiNisher (rw9188)
The finisher is exclusively designed for use with
Rockwell table saw RK7241s. (see T1)
• The Finisher planes to an accurate and fine finish,
the sawn face of lumber up to 3 1/8” thick and 11”
wide - perfect for furniture work.
• When used with the Sliding Extension Table, the
finisher planes away the saw chipped edge on
veneered or pre-finished sheets
• Fits in seconds, can be used with or without the
sliding Extension Table.
2. sliDiNG eXteNsioN table (rw9189)
The sliding Extension Table is exclusively designed for
use with Rockwell Table saw RK7241s.(see T2)
• Greatly increases the capabilities of the tablesaw to
handle larger work.
• 36 3/4” rip capacity, 26 3/4” cross-cut capacity.
• Miter cuts to all angles.
• Fits in a few minutes, packs away without losing
calibration.
• Ultra-compact folding for storage.
3. DaDo table iNsert (rw9556)
The dado Table insert is exclusively designed for use
with Rockwell table saw RK7241s.(see T3)
a dado blade makes a non-through cut which produces
a square-sided notch or trough in the workpiece
(requires a special blade).
do not use blades rated less than the speed of this tool.
do not use a wobble blade dado on this saw.
do not use a dado set larger than 6” diameter or wider
than 9/16”.
Note:
This saw cannot be used to make a bevel dado
cut.
MaiNteNaNCe
1. GeNeral MaiNteNaNCe
remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of
dust. if you see some sparks flashing in the ventilation
slots, this is normal and will not damage your power
tool.
if the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
2. lubriCatioN
Your power tool requires no additional lubrication or
maintenance.
all of the bearings in this tool are lubricated with a
sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions.