Rockwell RD2871, Руководство по эксплуатации

Страница: 9 / 12

9
18V LI-ION DRILL DRIVER EN
TECHNICAL DATA
RECHARGING BATTERIES
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
CHARGING PROCEDURE
1. CHARGING YOUR BATTERY PACK
A) The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not use
another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the machine
is switched off by means of a protective circuit: The
chuck no longer rotates.
In a warm environment or after heavy use, the battery
pack may become too hot. Allow time for the battery to
cool down before recharging.
When the battery pack is charged for the first time and
after prolonged storage, the battery pack will accept
a 100% charge after several charge and discharge
cycles.
B) TO REMOVE THE BATTERY PACK (See Fig. A1)
Depress the Battery Pack Release Button (7) firmly
first and then slide the Battery Pack out from your tool.
C) TO INSTALL THE BATTERY PACK (See Fig. A2)
Slide the fully charged Battery Pack onto the tool with
sufficient force until it clicks into position.
D) HOW TO CHARGE YOUR BATTERY (See Fig. B1, B2)
Connect the battery charger to the power supply and
the light (a) will be green.
Slide the battery pack into the charger base to make
the connections. And the light will change from green
to red to show charging has started.
After charging approx 3-5 hour, the light will change
from red to green, which means the battery is full, and
charging is completed. Then press the battery pack
release button and remove your battery pack.
NOTE: This charger is designed to detect some problems
that can arise with battery pack. (see table below)
Light ON/OFF flash Status
Red on
Charging
Green on
Fully Charged
OPERATING INSTRUCTIONS
1. ON/OFF SWITCH(See Fig. C)
Depress to start and release to stop your drill.
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure.
Speed is controlled by the amount of switch trigger
depression.
WARNING: Do not operate for long periods
at low speed because excess heat will be
produced internally.
2. SWITCH LOCK(See Fig. D)
The switch trigger can be locked in the OFF position.
This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger,
place the direction of Forward/Reverse rotating control
in the center position by pushing the direction buttons
on either side of the drill.
3. REVERSIBLE (See Fig. E1 & E2)
For drilling and screw driving use forward rotation
marked “ ” (lever is moved to the left). Only use
reverse rotation marked “ ” (lever is moved to the
right) to remove screws or release a jammed drill bit.
WARNING: Never change the direction of
rotation when the chuck is rotating, Wait until
it has stopped.
4.TWO-SPEED GEAR CONTROL (See Fig. F)
The drill has a two-speed gear control designed for
Rated voltage
Charger voltage
No load speed
Clutch position
Max. torque
Chuck size
Max. drilling capacity
Wood
Steel
Charging time
Machine weight
Charge battery
Protection class
Battery capacity
18V
100-240V~50/60Hz
0-400/0-1400/min
18+1
40N.m
10mm keyless chuck
35mm
10mm
3-5hr
1.36kg
Li-Ion
/II
1.3Ah