Rockwell Automation Allen-Bradley ClearMark 1492-PRINT110, Руководство пользователя

Страница: 71 / 80

Rockwell Automation Publication 1492-UM008A-EN-P - June 2010 8-1
Chapter
8
Troubleshooting
LED Displays
See the following table for the meaning of the LED Displays
Table 8.1 - LED Error Displays
LED Type Cause Troubleshooting Information
Transport Flashing
A marker card may be
stuck in the heating unit
Turn off the system and then turn it on
again in order to initialize.
The marker card is then transported out of the
printer.
If the card is not fed out of the printer, proceed
as follows:
• Turn off the printer and wait until it has cooled off.
• Unplug the power cord. If possible remove the marker card from
the system. Restart the system.
• If the problem remains, please contact your local Allen-Bradley
distributor or Rockwell Automation Technical Support.
Temperature
Flashing
Excess temperature was
reached
The heater is shut off immediately.
Wait until the heating unit has cooled off.
When the heating unit is cooled off, the system
will be automatically reactivated.
If the error occurs again, please contact your local Allen-Bradley
distributor or Rockwell Automation Technical Support.
Illuminated
Upper temperature limit
has been reached
The heating unit has reached a limit value.
The current print job is finished. The next
print job is then delayed until the heating unit cools.
but then automatically processed.
Heating 1 Flashing
The heating unit is
currently heating up Wait until the unit has reached its operating temperature
(< 1 minute).
Heating 2 Flashing
The heating unit is
currently heating up Wait until the unit has reached its operating temperature
(< 1 minute).
Heating 1 and Heating 2
Both Not
Illuminated The heating unit is not
activated
Heating is deactivated.
This setting can be used for sample test printing or for measuring
the system without print fusing.
Loader
Flashing
No marker card could be
separated and fed in.
Insert marker card and press the "Loader" button.
Illuminated Loader mode is activated
Not Illuminated
Loader mode is not
activated
Inlay (Printing material other
than marker cards)
Flashing
No inlay or marker card
could be fed in
Place an inlay on the conveyor and press the Inlay button