Rockwell Automation Allen-Bradley CENTERLINE 2500, Инструкция по эксплуатации

Страница: 67 / 88

Publication 2500-IN001A-EN-P - May 2006
Door Latches, Operator Handles and Unit Interlocks 7-9
Operator Handles for Circuit Breaker
In the event of a circuit breaker fault, the circuit breaker operator handle will
move to the TRIP/+ position. Only reset the circuit breaker after the cause of
the fault has been determined and corrected (see
Chapter 11 – Maintenance After
Fault Condition ). To reset the circuit breaker follow the steps below.
1. The operator handle will be in the TRIP/+ position.
2. Turn the handle to the OFF/O position.
3. Turn the handle to the RESET position. (Figure 7.12)
4. After the fault has been corrected, verify that it is safe to re-energize the
unit and turn the handle to the ON/
I
position.
Figure 7.12 Resetting a Large Rotary Operator Circuit Breaker Handle